Promocja!

Moblite7 Walksnail 1S 75mm HD brushless whoop V3.0 version (ELRS)

1000,00  z VAT

5 w magazynie

Najniższa cena ( 2023-12-29 ): 1160,00  Kategorie: , ,

Opis

V2.0 update log: Changed to GNB27 connector and V4 frame, no need 3d print battery tray anymore.  And changed the propeller to Gemfan 1635-3 propellers.

Specifications:
Brand Name: Happymodel
Model: Moblite7 Walksnail
Frame wheelbase: 75mm
Weight: 33.5 gram without battery
Size: 98mm*98mm*48mm
Receiver option:
SPI ELRS 2.4GHz
SPI FRSKY 2.4GHz
Compatible with 1S Lipo battery or Lihv battery
Battery Plug: GNB27

Package includes:

Item Name Qty
Mobula7 v4 75mm frame +Canopy 1
SPI Receiver Option1: SuperbeeF4 Lite FC built-in ExpressLRS SPI RX 1
SPI Receiver Option2: SuperbeeF4 Lite FC built-in Frsky SPI RX
RS1002 KV20000 Unibell brushless motor 4
Gemfan 1635-3 tri-blades propeller(4cw+4ccw) 1
Walksnail Avatar nano HD camera 1
Walksnail Avatar mini 1s tx module 1
Spare Canopy 1
Propeller disassemble tool 1
Screw driver 1
GNB27 to PH2.0 convertor wire 1

*The FPV goggle in the picture is for display only and is not included in the delivery package

Flight controller

SuperbeeF4 Lite ELRS/FRSKY

SPI ELRS version Firmware target: CrazybeeF4SX1280SPI
FRSKY version Firmware target: CrazybeeF4FR
MCU:STM32F411CEU6 (100MHz, 512K FLASH)
Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection)
Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot300 ready
Built-in Betaflight OSD(SPI Control)
Built-in SPI Frsky/ExpressLRS receiver
Built-in 5V 1A BEC
Built-in voltage detection
Onboard 4in1 ESC MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
Currents: 5A continuous peak 6A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_5_REV16_8.HEX
Default protocol: DSHOT150/DSHOT300/DSHOT600
Onboard SPI ExpressLRS 2.4GHz Receiver Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
RF Frequency: 2.4GHz
Telemetry output Power: <12dBmReceiver protocol:  SPI ExpressLRS
Could bind with ELRS V2.0 firmware TX module
Also support ELRS V3.0 , need upgrade betaflight firmware
Onboard Frsky SPI D8 /D16 2.4GHz Receiver SPI BUS receiver Frsky D8/D16 compatible
Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol
Motor Model: RS1002 20000KV
Configu-ration:9N12P
Stator Diameter:10mm
Stator Length:2mm
Shaft Diameter:Φ1.5mm
Motor Dimension(Dia.*Len):Φ13.5mm*12.5mm
Weight(g):2.5g
No.of Cells(Lipo):1S only
Propeller Gemfan 1635-3 Bi-blades Props Dia:40mm
Shaft size:1.5mm
Include 4pcs a pack
VTX Model: Avatar mini 1s VTX V2.0
Communication Frequency: 5.725-5.850 GHz
Transmitter Power(EIRP): FCC:<25.5dBm; CE:<14dBm; SRRC: <20dBm;MIC:<25dBm
l/o Interface: JST1.O*6(Power in)JST1.O*4(USB)
Mounting Holes: 25.5*25.5 mm
Dimensions: 30*30*6.5 mm
Storage: 8G
Recording: 1080p/720p
Weight: 6.8 g
Operating Temperature: -20-40℃
Channels: 8
Wide Power lnput: 3.1V-5V
Supported FC System: Betaflight
OSD: Canvas mode
Bitrate: 25mbps / 50mbps
Latency: Average delay 22ms
Antenna connector: IPEX
Camera Model: Avatar nano
lmage Sensor: 1/2.7”Inch
Resolution: 1080P/6Ofps,720P/120fps,72OP/6Ofps
Ratio: 16/9 4/3
Lens: 2.1mm
FOV 170°
Aperture: F2.0
Shutter: Rolling shutter
Min.Illumination: 0.001Lux
Weight: 3.5g
Dimensions: 14*14*17mm
Coaxial Cable: 45mm

Opinie

Na razie nie ma opinii o produkcie.

Napisz pierwszą opinię o „Moblite7 Walksnail 1S 75mm HD brushless whoop V3.0 version (ELRS)”

Twój adres e-mail nie zostanie opublikowany. Wymagane pola są oznaczone *